Routine maintenance

Warnings and precautions

 

WARNING  Only administrators and trained personnel should perform the maintenance procedures.

 

WARNING  Always turn off the robot and shut down the system before performing any maintenance procedure. See Turning on and turning off the robot and the system user documentation.

Maintenance tasks

 

Task	Frequency	Procedure
Clean up spills on any part of the robot after a protocol run.	Immediately	Use a clean soft cloth to remove the spill.
Inspect gripper pads for dirt, wear, tear, and cracks. Clean the gripper pads. Replace the gripper pads if necessary.	Monthly	See one of the following: • Cleaning the robot gripper pads • Replacing robot gripper pads

For preventive maintenance service, contact Automation Solutions Technical Support.

Related information

 

For information about...	See...
Shutdown procedure	Turning on and turning off the robot
Safety	BenchBot Robot Safety and Installation Guide
Replacing robot grippers	Replacing robot grippers
Replacing fuses	Replacing fuses
Assistance with maintenance procedures	Reporting problems