Recovering from an emergency stop

About this topic

This topic explains how to recover from an emergency stop after you pressed the red button on the emergency-stop pendant.

After you pressed the emergency stop button

After pressing the emergency stop button, you must restore the system for normal operation.

IMPORTANT You cannot always resume or recover a protocol run after pressing the emergency stop button. You might need to rerun the protocol after restoring the system for normal operation.

Before you restore the system, make sure you remove labware that might have been dropped during the emergency stop. Also remove labware at teachpoints or other locations.

To restore the BenchBot Robot after an emergency stop:

1	Restore power to the robot. To do this, turn the red button on the emergency-stop pendant clockwise. The spring-loaded button pops up.

 

2	If you stopped a protocol run in an emergency, select one of the following in each of the device dialog boxes to restore the device for normal operation:

 

Selection	Description
Diagnostics	Opens the device diagnostics dialog box. Note: This selection is available only when you are in the middle of a protocol run and not while you are already in the device diagnostics software.
Retry	Attempts to restart the current command or task in the run.
Ignore and continue	Ignores the current command or task and continues to the next command or task in the protocol sequence.
Abort	Aborts the current command or task in the run. Select Abort if you have determined that the protocol run is not recoverable.

3	If there is labware in the BenchBot Robot gripper, release it and move it back to the pickup location. To do this:

a	Determine the location from which the labware was picked up.

b	In the Robot Error dialog box, click Diagnostics.

c	Hold the labware in your hand so that the labware does not drop when you release it from the robot grippers.

d	Click Open in the BenchBot Diagnostics Jog/Move tab to release the labware to your hand.

e	Place the labware at the pickup location.

4	Click Abort Process in the Stop dialog box.

Exit and restart the VWorks software. Communication with the robot is re-established.

Related information

 

For information about...	See...
Pausing and resuming protocol runs	VWorks Automation Control User Guide
Shutting down the system	System user documentation
Turning off the robot	Turning on and turning off the robot
Using commands in Robot Diagnostics	Using BenchBot Diagnostics
Safety	BenchBot Robot Safety and Installation Guide
Reporting problems	Reporting problems