Unpacking the BenchCel Microplate Handler

About this topic

This topic describes how to unpack the BenchCel Microplate Handler from the shipping containers.

Shipping containers

The shipping containers include:

•	BenchCel crate containing the BenchCel device.

•	Peripherals box containing the following packages:

–	BenchCel utility kit

–

Pendant

–	BenchCel robot head

–	Safety shield with hardware

–	Labware racks

•	Computer box

Depending on the configuration ordered, additional packages or items can be included.

Before you start

Verify the following:

1	BenchCel utility kit contents. At a minimum, the kit contains the following:

•	Power cord

•	Serial and Ethernet cables, and Ethernet switch

•	Tubing for air line

•	Software CD-ROM

2	Site specifications. Ensure the installation site meets the requirements. See Verifying laboratory requirements.

Note the dimensions of the shipping container before moving it to make sure you have adequate clearance through doorways and passages.

3	Tools and equipment requirements. Obtain the following:

•	Large screwdriver to open the shipping crate

•	Hex wrenches: 5-mm and 2-mm for mounting the robot head

•	Cart for moving the BenchCel device

4	Personnel requirements. Make sure two people are available to lift the BenchCel device from the crate.

 

WARNING Heavy weight. Attempting to lift or move the BenchCel Microplate Handler without assistance could cause personal injury. Request assistance and use proper lifting techniques when lifting or moving the device.

Procedure

 

CAUTION The packing materials and shipping container were designed to protect the device. Packing the BenchCel device using other materials might damage the device and void your warranty. Save the packing materials and shipping container in case you are required to move or ship the BenchCel device.

To unpack the BenchCel Microplate Handler:

1	Use a large screwdriver to open the BenchCel device shipping container.

2	Lift the contents out of the container and set each item carefully on the lab bench or final location where you want to install the device.

3	Remove the packing foam from the device.

4	Remove components from the plastic bags or other packing material.

5	Inspect the unpacked items.

About installing the BenchCel device on risers

The 146-mm tall risers can be installed to the underside of the BenchCel device at each end to lift the device above the table surface. The risers are required for integrating the BenchCel device with certain devices in a workstation. In you are integrating a BenchCel Microplate Handler on risers, the Agilent installer will install the BenchCel risers before mounting the robot head on the BenchCel device.