Performing pre-run checks

About this topic

Before you start a protocol run, you should check the BenchCel Microplate Handler to ensure optimum operation. This topic provides the list you should check before each protocol run.

Procedure

To check that the BenchCel Microplate Handler is ready for a run:

1	Make sure there are no stray microplates in robot-accessible locations, including:

•

Platepads

•	External device plate stages

•	Third-party device areas that will accept labware from the BenchCel Microplate Handler

2	Remove any obstacle in the robot’s pathways. Consider the path of the robot head and arms.

3

For the devices that require compressed air, make sure the air pressure meets the operating requirements. For the BenchCel Microplate Handler air supply requirements, see Verifying laboratory requirements. For other Agilent Technologies devices, check the user documentation for the device. For third-party devices, check the product’s user documentation.

To check the BenchCel Microplate Handler internal air pressure, see Adjusting the stacker gripper pressure.

4	Make sure all devices and accessories are set up correctly and prepared for the run. For instructions, see the user documentation for the device or accessory.

Related information

 

For information about...	See...
BenchCel Microplate Handler air source requirements	Verifying laboratory requirements
External device air source requirements	External device user documentation
Diagnosing air pressure problems	Maintenance and troubleshooting