About performing mock runs

What is a mock run?

A mock run uses empty or water-filled labware. A mock run allows you to troubleshoot a protocol or a component of the system without wasting valuable reagents and samples. You should always perform a mock run to check a new protocol.

Correcting teachpoint errors

After setting the teachpoints, be sure to perform a dry run as a final check for any teachpoint errors.

Preparing for a dry run

You prepare for a mock run the same way you would prepare for a real protocol run, except that you use empty labware for a totally dry run or labware containing water for a wet run.

See Planning for the protocol run.

Related information

 

For information about...	See...
Stopping the device in an emergency	Emergency stops
Writing protocols	VWorks Automation Control User Guide
Preparing for a run	Workflow for preparing a protocol run