Performing pre-run checks
About this topic
Before you start a protocol run, you should check the BenchCel Microplate Handler to ensure optimum operation. Perform the following procedure before each protocol run.
Procedure
To check that the BenchCel and integrated devices are ready for a run:
1 Ensure the labware racks are filled with the correct labware.
2 Make sure there are no stray microplates in robot-accessible locations, including platepads or plate stages on integrated devices.
3 Remove any obstacle in the robot’s pathways. Consider the path of the robot head and arms.
4 For the devices that require compressed air, make sure the air pressure meets the operating requirements.
To check the
BenchCel internal air pressure, see
Adjusting the stacker gripper pressure.
5 Make sure all devices and accessories are set up correctly and prepared for the run. For instructions, see the user documentation for the device or accessory.
Related information