When relidding microplates on the Bravo Platform, you add the Relid task within the Bravo Subprocess. After adding the Relid task at the desired point in the Bravo Subprocess, select the microplate you want to relid in the Task Parameters area, as the following example shows.

You do not need to select a device for the Relid task. The system automatically uses the correct device to relid the microplates.

On the Bravo Platform, remove a lid from the Source Plate for an Aspirate task. After the task is finished, relid the microplate.

Within the Bravo Subprocess, add a Delid task before the Aspirate task to remove the lid. Add a Relid task after the Aspirate task to place the lid back on the microplate.

The task parameters for the Delid and Relid tasks are:

The device selection for the Delid task is as follows. Note that you do not need to select a device for the Relid task.