BenchCel User Guide : Preparing for a run : Workflow for operating the BenchCel Microplate Handler
Workflow for operating the BenchCel Microplate Handler
About this topic
This topic presents the workflow for operating the BenchCel Microplate Handler.
Before you start
Make sure that you have:
• Initialized the correct profile. See Creating profiles.
• Verified the teachpoints per Verifying the teachpoints.
• Set the Plate-presence and Orientation thresholds for the type of microplate you are using. See Setting sensor thresholds.
Workflow
 
Step
For this task...
See...
1 
Place the labware into the rack and mount the rack on the device.
2 
Perform pre-run checks.
Performing pre-run checks
3 
Prepare devices and accessories.
Device user documentation
4 
Open a protocol in the VWorks software.
VWorks Automation Control User Guide
5 
Start and monitor a protocol run.
VWorks Automation Control User Guide
6 
Clean up after the run.
Cleaning up after a protocol run
Related information
 
For information about...
See...
Defining the labware
• VWorks Automation Control Setup Guide
Pausing a run
VWorks Automation Control User Guide